Mussel-Rope Part Two

Further to our recent mailout where we discussed mussel rope at perched/overhanging structures, it’s now time to look at mussel-rope when placed within culverts.

Mussel-rope is one of the tools that can be used to help improve fish passage where fast, laminar flow is present.

If it is not viable to remove an existing culvert or is not practical to fit baffles due to the small diameter (e.g. under 750mm or 2 &1/2 feet), then mussel-rope can be considered as a remediation tool.

Obviously, the rope does not retain bed material, create rest-pools or the complexity that baffles do. Therefore rope should only be used as a last resort, and it should not be used at new culvert installs.

Below are some CFD images that show the effects the mussel-rope has on the depth and velocity in culverts.

Model setup
No rope/rope comparison. 
12Lt/sec
12Lt/sec. 5 Degree slope
12Lt/sec. 5 Degree slope

Understanding Mussel-Rope

Understanding Mussel-rope Part 1

Many culverts are barriers to fish due to being perched/overhanging or having fast laminar flow.

In the video below, Tim demonstrates how mussel-rope can improve fish passage at perched/overhanging structures.

The rope simulates natural tree roots and fibres that some species have evolved to utilise when migrating upstream.

The type of rope being used here is “looped mussel-rope”.

Looped rope is proving to be an effective remediation tool at perched/overhung structures. It also has the benefit of not shedding fibres as readily as other types of ropes.

Mussel-Rope Heads-Up

Many of you will be familiar with the use of mussel-rope to help improve fish passage over or through structures including culverts.

The rope helps to reduce the water velocity adjacent to the rope and also gives a tactile surface for small fish to wriggle through or over.

Rope is a good tool when there is no other option, however it does not create resting pools, add depth, or retain bed-material.

While we have installed many 1000’s of meters of mussel-rope, it is important to understand that there are limitations as to where mussel-rope can be used and where it is not suitable.

Mussel ropes can be used to enhance fish passage on existing structures where: –

  • Culverts are perched and fitting ramps is not practical.
  • It is not practical to install baffles e.g. culvert diameters <800mm

Other notes:

  1. Based on our extensive experience, it is best not to attach the downstream end of the rope as this has been known to cause blockages when logs, debris etc gets caught under the rope.
  2. Fixings should be roust e.g. stainless steel D-ring and clasp – NOT a waratah.
  3. “Swimming lanes” are rarely achievable when installing ropes through smaller diameter pipes because these pipes typically have very low flow. It is even more challenging if the pipe is also long.
  4. There is no evidence that “swimming lanes” are more effective than a number of ropes laying close beside each other.
  5. When aiming to get fish up a perched or overhanging structure, it is best to first attach a strip of rubber in order to create a wetted margin.                                    See Tim’s video link below.
  6. Looped-rope is less likely to shed fibers than Super-Christmas-tree rope and there is no evidence of it being more likely to cause a blockage.
  7. The cut ends of the ropes should be melted to prevent fraying.
  8. If rope is used through a culver that is also overhanging, there should be twos sets – one set attached at the upstream end and finishing at the outlet, with a second set attached at the outlet hanging down into the plunge-pool.

In summary:

Mussel-ropes should only be used as a last resort when remediating existingstructures where ramps, baffles etc are not practical.

We are always willing to listen, help. share and learn, so please feel free to contact us however and whenever..